[ZCU106] Cannot detect the SSD about fpga-drive-aximm-pcie

[fpgadeveloper]

Hi,
Please try downloading the prebuilt boot files and testing them on your hardware. They have been tested on our hardware and with the same SSDs.
Dual design: https://opsero.com/downloads/boot/2020-2/zcu106_hpc0_dual-petalinux-2020-2.tar.gz
Single design: https://opsero.com/downloads/boot/2020-2/zcu106_hpc0-petalinux-2020-2.tar.gz
Please use the Opsero contact form for more support on this.
Jeff

[CaglayanDokme]

Hi Jeff,
Thanks for the quick reply. The prebuilt image works fine. I've got a few questions for you.

I tried to regenerate the Vivado and PetaLinux projects using the scripts you've provided. The Vivado version I use is 2018.3 and the tickle script states that it should be 2018.2. So, I upgraded the tickle file by just modifying the version_required variable. Would it cause a big difference between final products? I guess that the PetaLinux version also differs. Thus, I would be appreciated if you could tell me whether it would be a problem or not.

UPDATE

Using the tickle file of version 2020.2, I had just generated a .bit file in Vivado 2018.3 and packaged it with a proper FSBL and U-Boot binary. Then, I tried to boot the board using the BOOT.bin of mine, and the prebuilt image.ub you've provided. Unfortunately, the board didn't boot. (Stalled after the Xilinx DPDMA engine is probed.) I was actually expecting a successful boot. What would be the reason for the failure?

UPDATE 2

I think I've got some good news. This morning I tried to boot the system with a different configuration which includes the BOOT.bin you'd provided and the kernel image_(device tree and rootfs also)_ I generated. Luckily, the design works well. I managed to detect both of the SSDs with the lspci utility. Therefore, I'm pretty sure that the problem is related to the generation of .bit file.

Thanks.

[fpgadeveloper]

Contact me through the Opsero contact form.