silver13 / h8mini-dual Goto Github PK

I buyed new quad flash that firmware everything is ok but the quad is going back left in acro and in level mode when quad is horizontal back left motor not spinning but when i rotate quad in that direction motor normally start to spin i dont think its motor problem i think there is something whit the code HELP

Hi as title says i need to flip the quad without throttle but its imposible now is there any way to do that i really need it for tricks

Good, thanks for your good work. my question is if you can put the quad in both h8 airmode mode and H101. and I would also like to know if you offer them support eachine E010 board as these are difficult to adapt to this model by its form in X. greetings and thanks

First off, thanks for this firmware! So cool to toy around with the h8's behavior like this.

I've added some new stick gestures to the firmware to turn headless mode on and off but was wondering if there's a direct way to do it which takes less time. I'm sending the stick gestures through and arduino imposing an artificial delay between each stick direction. It would be great to trigger things in one go. Maybe by using a trim?

Any ideas? I have it all connected exactly as prescribed in the video..

First its not motor fault it must be in code but i need to make one motor little bit faster then others is that possible somehow ?

Hello guys, I flashed an H8 mini with the silverware and it all worked fine until today, where I also flashed the software to a H8 of a friend. Now the top right motor only spins if I hold the Quad upside down. So I guess there is something wrong with the gyro. This causes an instant flip on the ground if I want to take of. The acromode works fine, but not levelmode. I also tried to calibrate the gyro but that doesnt help. I also didnt changed any setting in the config. The issue appeared after I flashed it to the H8 of a friend and on mine. Both have the same problem now.

I dont like to open new issue when i have a question so i decided to just make this.
my question what ENABLESTIX_TRESHOLD do when i change it up because i want ENABLESTIX a lot faster because its slow for me so im asking you Thanks

Autolevel after flip pitches in the opposite of the flipped direction.

are you sure the clock configuration is correct ?
to me it seems that the GD32F130G6 should run at 48 MHz according to the Datasheet
and from the pwm driver it seems as if the peripheral clock running at ~4 mhz (490*8192)? shouldn't that be the same as the system clock ?

I could flash the FW for the blue board from the other repo (H8mini_blue_board), but this doesn't seem to work. Is there a dual mode version which works with a blue one?