lu7did / pixiepi Goto Github PK

Sidetone GPIO19 is not working while transmitting CW.

Implement full configuration thru a settings file for headless operation.

3D Printing requires the following changes.

• Blind case for headless operation (no LCD/Rotary Encoder).

• Higher case to allow for cabling.

• Case needs to be 90 degrees from plate.

• Replace pilar for Raspberry Pi (use similar to Pixie, hole instead of pin).

• Review areas without material.

• Review legends, pair with printing resolution.

• Re-layout vents.

• Secure upper case with bolts instead of pressure strip.

implement formal logging both at console and file using INFO,DEBUG,ERROR,CRITICAL levels

Implement PSK31 mode

Implement settings based configuration for full headless operation without LCD/Rotary Encoder

On continuous modes such as FT8, PSK31 or RTTY the final PA transistor blow up from a thermal runaway, a thermal sink is needed.

Enable PWM at GPIO19 for the operation of SIDETONE (feed thru Pin 7 of LM386)

Implement FT8 mode

Implement RTTY

Implement SSTV