Fault message on Bosch compress 3800i ew: A11-3071 about ems-esp32

[MichaelDvP]

A11-3071 indicates that there was remote thermostat connected and is now missing.

Indeed in Take.04.-.change.temperature.txt there is boiler(0x08) -B-> All(0x00), UBADevices(0x07), data: 09 01 00 00 00 00 01 00 00 01 00 00 00 00 00 configured devices 0x08, 0x0B, 0x10, 0x38 and 0x50.
Device 0x38 is a remote thermostat for hc1 and 0x50 is a M200/RFM200 module (product-id 218, seen in BF message).
emsesp-system-allvalues.txt shows the entity remoteseltemp in thermostat. This value can only be set by a remote thermostat, not by ems-esp, but in emsesp_system_info.txtx these devices are not listed.
Also in log.txt there is boiler(0x08) -B-> All(0x00), UBADevices(0x07), data: 0B 01 00 00 00 00 00 00 01 00 00 00 00 only devices 0x08, 0x09, 0x0B, 0x10, 0x48, no M200 and no remote thermostat, but in 'thermostat(0x10) -W-> Me(0x0B), RC300Set(0x02B9), data: 00 00 2A 00 1E 00 00 00 FF 00 2A 00 00 00 00 00 00 2C' the remoteseltemp is still set.

It's difficult to analyse anything if you change configuration, devices, software version, etc. and mix all in one issue-report without explaining. The error message is because you had connected a remote and disconnected it again. It is not related to ems-esp.

What I noticed, fan control is missing(at least)

See https://emsesp.github.io/docs/FAQ/#decoding-ems-telegrams

[mattfro]

Hmm... I don't understand. Just tried to power the pump off, without ems-esp no alarm. Then connected it again, I get the alarm.
I don't have any indoor temperature sensor. Only sensor connected is outdoor to the pump.

So should I again from scratch, reset ems-esp gateway. turn off pump, turn it on. Leave it for a while, then turn it off and connect ems-esp gateway again. See if it's working?

[mattfro]

I'm sorry, this was my bad. I get the alarm also without it, just took some time. And now I can't get rid of it... I wonder if some cables got disconnected or something.
Or something got stored in the pump for a for a roomsensor, when I tried to activate it. But I disabled it and even reset ems-esp. Cut the power from the pump etc.

I can't find any settings in the pump to be able to activate or disable any roomsensor. I have a feeling, it automatically knows if it's connected or not. But maybe it's stupid, once it thinks it has a roomsensor it will never forget it. I might need to do a full reset on the pump. Maybe that helps. Sorry for this ticket then. We can close it and open a new if needed.