zruncho3d / f-zero Goto Github PK

Panel lower lip is superfluous and interferes with 1515 rail, see image

Fix: remove it from sketch2. SidePanels have no lip either and relocating it would require supports while printing.

reported by: eduncan on Discord

The "Panel" lacks the holes for the brass inserts on one side. The holes are also too big!

Fix:

• change Model Parameter:Panel:sketch1:Diameter Dimension-2 [d67] from 5.8 to 4.8mm
• Activate Panel and mirror extrude2 on YZ plane

The Meanwell 150W PSU that is supplied in the LDO V0.1 (and V0.2 I think?) kits is larger than the CAD's version of the 100W.

Hole to screw down the PSU doesn't align with the deeper 150W variant (look for the hole in the baseplate).

There's also no room for the buck converter here either.

Reported by coilboii on Discord - thanks!

The hole is obviously at the wrong position.

Fix: RearCornerTop::Sketch13 dimension[d274] should rather be 11.5mm from rear face, not 7.5mm from panel mount.

The top lip interferes with the corner clip by 4.1mm
FIX:

• In Panel move the history just before the mirror feature introduced in issue#8 fix (missing inserts in panel).
• Use ::Sketches::Sketch2 to cut off 4.2mm of the panels upper panel lip. Add this feature also to the mirror feature and move history again to the very end.

Example: https://discord.com/channels/825469421346226226/841961639351812107/974558299334795274

Need to modify the Z units to push screws back, plus add clearance in skirts for existing Z unit prints.

https://discord.com/channels/825469421346226226/841961639351812107/974575536762421248

It is a bit related to #5 , because I (and several others in Discord) thought it was the skirts that needed modifying.

https://discord.com/channels/825469421346226226/841961639351812107/974575536762421248

So, we... uh, modified (drilled holes) our front skirts to clear the motor mount screws, before we knew the Nema17 mounts had counter-sunk holes!

The extrude feature is suppressed in the history....???

FIX: un-suppress the extrude feature for the "Extender" object and change its depth to -4.2mm. Also a 0.4mm chamfer would be advised.

https://discord.com/channels/825469421346226226/841961639351812107/974617830509125652