wdcossey / ppm-to-ibus-serial

Decodes RC PPM signal and re-encodes it to IBus over serial.

ppm-to-ibus-serial

This sketch enables you to use your PPM receiver with VJoySerialFeeder.

Essentially it'll decode a PPM signal and re-encode it to IBus and transmit it over the Arduino Serial.

The Arduino sketch can be found from here, build and upload to your Arduino of choice.

Don't use this sketch if your receiver already supports IBus (pretty pointless).

This sketch will:

• Automatically detect the number of PPM channels (no fixed numbers).
• Pads any unused IBus channels (with a default value of 1500).
• Generate a valid IBus checksum.

Hardware requirements:

• Arduino (Interrupt PCINT0, D8 on the Uno).
• PPM receiver.

Software requirements:

• VJoySerialFeeder (see the page for additional requirements).

ToDo:

• Remove PPM jitter.

ppm-to-ibus-serial's Issues

Jitter

Hi, any updates for the jitter problem?

:)

not working

Hi,
I am using Arduino UNO R3 and flysky reciever X6B (with PPM output).
pinout: 5V - 5V, GND - GND, PPM - D8 (PCINT0)
Sketch successfuly uploaded into arduino (no changes in code).

I want to use it with VJoySerialFeeder, but there is not output from reciever.

Normally I am using X6B with PPM output (ibus is broken) together with Flysky i6 and it works, but not here with arduino...
Any hints? Maybe settings in VJoySerialFeeder?

can we use the ppm port on backside of FLYSKY transmitter with arduino(aux method does not work because realtek interferes)

this is not a issue but a question
looking forward for an answer, thanks :)

hitec optic 6 PPM not working

Optic 6 to Corona receiver CR8D. Corona receiver to nano with ppm-to-ibus flashed. Vjoy config and serial feeder loaded. ibus selected.

No signal.

All protocols tried.

No signal.