While your project is working well, while running this ESP 32 Cam module, within a couple of seconds, the connectivity is disconnected, and on the serial monitor, I can find out the temperature level is reaching above 40 °C and automatically shuts down. If you're facing this kind of issue, can you assist me in resolving the query, for a couple of seconds, it's working well. I have tried out the AC room and different 5-volt DC power resources with the ESP 32 Cam shield board, and I am facing the same issues.
I have tried with another ai thinker module (new one) with even this one also I am getting the same error mess find the serial console log as below I have check it for AI thinker cam module and tired with webcam example sketch from ESP32 on new module its working normally, I in my area 30 to 55 c is normal in some areas I want to build bike cam with your project
11:21:48.361 -> My Dash Cam v1.0
11:21:48.361 -> ==============
11:21:48.361 -> E (495) gpio: gpio_install_isr_service(449): GPIO isr service already installed
11:21:48.549 -> UXGA-1600x1200 Camera..OK
11:21:48.625 -> SD Card..OK
11:21:48.625 -> WiFi password -> 12345678
11:21:48.749 -> Camera IP Address ->http://192.168.4.1
11:21:48.749 -> Last image save 'image255.jpg'
11:21:49.154 -> 1000428../image00256.jpg
11:21:49.154 -> 81.67°C
11:21:49.154 -> Over temperature shutdown at 60°C
can you assist me in resolving the query