tuannat / waltmech-m1

M1

`The WaltMech M1 is the successor project of the MouseRig

• print volume: 150x150x150
• Framesize: xyz 296x344x440
• Fusion 360 viewer

summary of the changes and improvements:

• custom aluminum sheets have been removed
• the drive runs on ball bearings and 6mm belts
• the XY-drive was placed on top of the profiles
• the filter is integrated in the housing
• Reduced size of V2 compared to MouseRig
• smaller motors were used for the Z axis
• blind joints instead of corner plates
• much less screws and hammer nuts
• The number of profiles has been reduced
• Easier to build and much more cost-efficient than the previous model

---

Special thanks to Liam Venter for letting me use his Ventermech Stars

fastbikegear.co.nz