tschaban / sonoff-basic-firmware Goto Github PK

h3 class="red">Aktualizacja nie powiodła się

Hello,

I attached both temperature sensor and extnernal bistable switch to sonoff basic.

If bistable switch is ON (loop closed = GND is connected to GPIO1), then after powering off sonoff it won't start, no led blinking, no wifi presence, nothing or works very unstable (very slowly loads part of configuration page).

After changing the circuit to open and replugging sonoff, it starts normally.

If I use GPIO sonoff works "boots up" always, regardless external switch state.

this is rather minor problem, greetings

siec, ktorej szukasz ;)
czesc, co slychac? ;)

and enabling configuration mode by pressing button for 12 seconds

Hi

Would it be possible to add a mesh capability?

Regards,
Johan

Change it to: Finish configuration (usability request)

Hello,

I wish AFE had the following functionality settings:
When wifi or mqtt goes down for an extended period of time (amount of time to set), do:

Change state of relay to (selectable options): no change, turn off, turn on
There are already settings for changing state when MQTT connection is back, but imagine situation then for some reason wifi router or mqtt server dies, sonoff is left all alone and we're out of the home - heating/watering/A/C keeps running until we do return and may cause some problems or at least boil fish in aquarium if not equipped in own timer/themostat.

Greetings!

potential usage for Domoticz and other automation platform - alternative to mqtt

is it possible to connect esp to EWeLink app with this firmware?

There are 3 GPIOs

• GPIO1
• GPIO3
• GPIO3

For each GPIO give option to set

• switch mono or
• switch bi
• ds18b20

For now there could be only one ds18b20 connected