thestealth131205 / megapirateng-add-ons Goto Github PK

Quad X/1300kv/F-30A Simonized/Ublox/Bluetooth on RCtimer Crius aiop v2.
Erase eeprom in mission planner. Deleted Arduino 1.0.5/installed 1.0.3. Deleted 
old megapirate/downloaded new 2.9.1b R8 add on. No errors while uploading to 
board.

Using mission planner 1.2.55 - Acc/TX/Compass calibration are good. ESC 
calibration successful.

PROBLEM: When I activate with right rudder, give throttle, motors start to 
increase speed and then all of a sudden 1 or 2 motors rev up 100% for a split 
second - like a major motor twitch. I tried this from 0-50% throttle with quad 
in my hand and every few seconds this will happen.

What I tried - Recalibrate tx/esc`s a few times, deleted megapirate/arduino 
from my pc, erased eeprom and tried this for 2 more times. Checked odd 
tx/throttle behaviour in mission planner, but none. 

After flashing the current firmware I'm not able to configure the Accelerometer 
in Missionplaner.

Missionplaner is running through the setup so fast, I can't lay the Quad on it 
sides.
Maybe it's an Missionplaner bug, but it only occurs with this firmware.

I'm using the "Multiwii and Megapirate AIO Flight Controller w/FTDI (ATmega 
2560) V2.0", Windows 8.1 with the newest Missionplaner 1.3.10.

In Flight-Data the horizon is flipping/jiggling around, so the Accelerometer 
shows an unnatural movement.

What steps will reproduce the problem?
1. Change config to AIOP V2.
2. Compile
3.

What is the expected output? What do you see instead?

It refuses to compile with multiple errors.

What version of the product are you using? On what operating system?

The latest. Windows 8.

Please provide any additional information below.

I am using AIOP v2 controller, Ublox GPS, 6x hextronic 750kv motors and 6x 30A 
SimonK Firmware Multicopter Speed Controllers.

I enabled the gimball when uploading the firmware but nothing happens. 
I am using this gimbal: CM102 2-Axis Carbon Fiber Camera Gimbal Mount.
When in plug in the power the servos turn them in one end direction and this is 
all what they do. I have tried putting them under RC channels in mission 
planner but this does also nothing. When i use RC8 then a motor starts to spin. 
All smaller RC channels are staring a motor. 

Is it possibel to use my gimbal with this firmware or not? If it is then what 
should i do?