taloot / taloothc

Linuxcnc THC for fiber laser and plasma,, based on esp32,,, all variables can be set using webgui

TalooTHC

THC for fiber laser and plasma,, based on esp32,,, all variables can be set using webgui it convert analoge signal to PWM freq,, with defined range min and max read capacitance and conver it to PWM , with min max calibration, for fiber laser,, co2 auto foucas, or flame cutter designed to work with Linuxcnc Torch Hight Controller,

Main Features

• 12 bit ADC.
• 6khz sampling rate.
• adjustable pwm output range.
• display graph for analog and digital frequency.
• IIR filter for Capacitance Value.
• setting Data saved in eeprom.

https://www.youtube.com/watch?v=CStLGPyVeLw

How to use :-

there is Sketch and data here is the method of uploading, Sketch, and Data

https://randomnerdtutorials.com/install-esp32-filesystem-uploader-arduino-ide/

define your SSID, then upload the sketch,, open serial monitor, and u can see your ip.. use it in ur web browser

and access the configration for it from webgui

my esp32 similar to this https://roboticx.ps/?attachment_id=4630 make sure u use the right PIN,,

GUI ScreenShot

taloothc's Issues

For use with BCL-AMP?

I am working on a LinuxCNC-controlled fiber laser cutter. I was following the discussion over at https://forum.linuxcnc.org/plasmac/38701-plasmac-fiber-laser-1kw-head-height-control-auto-focuas and it seemed like when you switched to the BLC-AMP you may no longer need this code. I have a BLC-AMP, but I have not been able to find a data sheet for it. Do you have any information you'd be willing to share? Thanks!

Scott