Laser Mode Enabled after every Draw Frame action about octoprint-bettergrblsupport

[synman]

Remember, I only have a laser :)

Will take a look at this and see about cleaning up.

Shell

[AlligatorFate]

I think my tone was wrong... sorry. I meant to be persuasive, not critical. It's all about continuous improvement, right?

[synman]

I'm working on factoring out system ($) command interactions as much as possible right now, focusing initially on removal of all $32 commands within the plugin (except for when you want to change them via Grbl Settings).

[synman]

Tying this together with #35 and #4

This is turning into an extensive, but very necessary, exercise. I've brought a lot of stuff into scope here including laser detection based on $32 value, usage of Grbl 1.1 jogging for framing operations, and backwards compatibility for older devices.

I'd rather just drop support for pre 1.1 firmwares but recognize there are probably a bunch of people stuck on .9.

I'm also revisiting all embedded gcode and refactoring many of the commands used by the plugin today for various operations.

Lastly, I've finally, just moments ago, pulled trigger on a budget CNC machine. I went with this bad boy: https://www.foxalien.com/collections/cnc-router/products/cnc-router-machine-masuter-with-300w-spindle-bundle-kit

So yeah, anticipate some major improvements over the next month or so as I adapt the plugin to cover all my own CNC needs.

Shell

[synman]

this should be fixed. please comment if you observe otherwise