An internal MPM (Multi-Protocol Module) for Flysky PL18 Mod
This internal module works with the modified version of Flysky PL18 that flashes with EdgeTX:
https://github.com/EdgeTX/edgetx/wiki/PL18-Hardware-Mod-for-Complete-EdgeTX-Support
For MPM firmware download, please visit the official page:
https://github.com/pascallanger/DIY-Multiprotocol-TX-Module
- Add an antenna to the PL18
- Solder the power control wire to PI.00 pin
- Install the PCB and insert the power control pin, you may need to use a stocky tape to ensure the MPM PCB is fixed to the PL18 PCB properly.
Note: The 100k pull up resistor for the power control pin is for testing purpose, it DO NOT NEED to be soldered as per the images shown.