qiuxiaoye / cpf_iot

cpt iot project docker container deployment

IOT PROJECT

This CPF IOT Project is for raspberry pi installation. It helps IOT software to be quicklly deployed to raspberry pi.

Present sensor collect the human presence data from MMwave Sensor. Data was transmitted using MQTT and received by raspberry pi using zigbee dongle. Raspberry Pi capture data using Zigbee2mqtt and paho and upload data into Azure Cosmos db.

All software installation is pre-configed by docker-compose

Hardware Requirements

1. Plug in Power
2. Plug in MicroSD Card
3. plug in Zigbee Dongle

Software Requirements

1. Install Raspberry Pi OS
2. Raspberry Pi Account Setup (optional)
3. Install Docker and Docker Compose

Command

sudo docker-compose up -d --build

sudo docker-compose up -d sudo docker-compose down

Raspberry Pi Configurations

1. Keep Pi Always On. (Under Testing.....) https://chat.openai.com/c/11389311-64a6-4017-9177-6c69a0725af0 First, update your EEPROM firmware to the latest version: sudo apt update sudo apt full-upgrade sudo rpi-eeprom-update -a sudo reboot Then, configure the EEPROM to set the power-on behavior: sudo -E rpi-eeprom-config --edit In the editor, look for the POWER_OFF_ON_HALT setting and change it to: POWER_OFF_ON_HALT=0 WAKE_ON_GPIO=1 Save and exit the editor, and then apply the changes: