hipi's Introduction

HiPi

Specifications

TODO

Software

Hipi board use a SPI to UART component (sc16is752) to communicate with Dynamixels motors. To use the HiPi board on a Raspberry Pi, you have to install and configure a driver.

Quick setup

You can install the drivers, and the starup script of the HiPi with this command:

curl https://raw.githubusercontent.com/poppy-project/HiPi/master/install_hipi.sh | sudo bash

After a reboot, you will be able to comunicate with the motors on:

/dev/ttySC0 for TTL1 and RS4851 Hipi output
/dev/ttySC1 for TTL2 and RS4852 Hipi output

Detailed instructions

Without the install script, you can do it by hand:

you need to add the sc16is752 overlay in /boot/overlays
you need to add the overlay configuration dtoverlay=sc16is752-spi,clkrate=32000000,irqpin=13 in /boot/config.txt
due to Hipi hardware, you need to open serial ports /dev/ttySC0 and /dev/ttySC1 (serial ports of the HiPi board) in RS485 mode (whatever TTL or RS485 Hipi output you want to use). It can be done one time at startup and the configuration will stay afterwards.

This snippet will open and close /dev/ttySC0 and /dev/ttySC1 ports in RS485 mode:

import serial.rs485
ser = serial.Serial('/dev/ttySC0', 1000000, timeout=0.5)
ser.rs485_mode = serial.rs485.RS485Settings(rts_level_for_tx=False, rts_level_for_rx=True, delay_before_tx=0, delay_before_rx=0)

ser2 = serial.Serial('/dev/ttySC1', 1000000, timeout=0.5)
ser2.rs485_mode = serial.rs485.RS485Settings(rts_level_for_tx=False, rts_level_for_rx=True, delay_before_tx=0, delay_before_rx=0)