a small typo: "prerequisite" for "dependency check" about pyfluxpro

[sunxm19]

Another tiny typo in Level 2: quality control check:
SONIC_Check uses the sonic anememeter diagnostic word, .....
IRGA_Check uses the IRGA diagnostice work ....
(not sure whether it would be "word" or "work").

Any records rejected from Ta_HMP_10m will "laso" be rejected from AH_HMP_10m.

[sunxm19]

In paticular, the L1 time series for Fe_EP and Fh_EP (plotted in blue) show "now" (should be "no") seasonal variation.

[sunxm19]

The yellow line is the average value as a function of "thime" (should be "time") of day for the whole data set

[sunxm19]

Tiny typos for For L3:

Calculate the turbulent fluxes (Fco2, Fe, Fh, Fm and ustar) from the variances and covarinces ("covariances") after applying the 2D coordinate rotation, correcting for low- and high-frequency losses, converting from virtual heat flux to sensible heat flux and applying the Webb Pearman Leuning (WPL) correction.

Convert CO2 concentration and flux to mkixing ("mixing") ratio and molar units respectively and correct the CO2 flux for storage if requested.

soil parameters used to correct the measured ground geat ("heat") flux for storage are contained in separate Massman and Soil sections.

The Files section allows the user to specify the path to the input and output files, the names of the input and output files and the path for plots generated by the L2 (should be "L3") processing, see the screenshot below.

plot_path - the path for plots generated by the L2 (should be "L3") processing

UseL2Fluxes controls whether or not PyFluxPro will calculate the turbulent flxes (should be "fluxes") from the variances and covariances.