Replace "fake" enumerations with enumerations in VehicleInterfaces.Types about vehicleinterfaces

[tobolar]

Actually, work on this issue shall be coupled with #28 as well.

The GearMode and IgnitionSetting are both used in DriverEnvironments.Internal.StandardBus which shall be reintroduced again. This StandardBus is marked obsolete in current v1.2.4 but this must be reverted in the next major version.
In contrast, busses in e.g. DriverEnvironments.Interfaces shall be marked obsolete and no more used.

Here are listed classes where concerned "fake" enumerations are used:

• VehicleInterfaces.Types.GearMode

  • DriverEnvironments.DriveByWireAutomatic as selectedGearboxMode
  • DriverEnvironments.Interfaces.BusForAutomaticTransmission as gearboxMode
  • DriverEnvironments.Internal.StandardBus as gearboxMode
  • Drivers.Interfaces.BusForAutomaticTransmission as gearboxMode
  • Drivers.MinimalDriver as selectedGearboxMode

• VehicleInterfaces.Types.IgnitionSetting

  • DriverEnvironments.Interfaces.MinimalBus as ignition
  • DriverEnvironments.Internal.StandardBus as ignition
  • Drivers.Interfaces.MinimalBus as ignition

[tobolar]

Well I have analysed this and it doesn't seem to be feasible at the moment. The problem is that the "enumerations" are mainly used in control busses. And to work with the busses in Diagrams would require particular graphical blocks for enumerations, which are not available. See also comment modelica/ModelicaStandardLibrary#91 (comment).

It would be possible to use the enumeration for the parameter selectedGearboxMode in driver models. But I see no benefit of doing so because then there have to be some transformation of enumeration parameter to integer on control bus. So rather tricky and confusing solution.