mikroelektronika / ecg_4_click

Library for BMD101.

---

ECG_4 Click

• CIC Prefix : ECG4
• Author : Nemanja Medakovic
• Verison : 1.0.0
• Date : Dec 2018.

---

Software Support

We provide a library for the ECG_4 Click on our LibStock page, as well as a demo application (example), developed using MikroElektronika compilers. The demo can run on all the main MikroElektronika development boards.

Library Description

The library performs the ECG and Real-time Heart Rate measurements. For more details check documentation.

Key functions :

• void ecg4_response_handler_set( void ( *handler )( uint8_t*, uint8_t*, uint8_t*, uint8_t* ) ) - Function sets handler on the function that should be performed, for example, function for results logging.
• void ecg4_uart_isr( void ) - Function performs the uart interrupt routine, reads a data from uart rx buffer and makes a response from the BMD101 device.
• T_ECG4_RETVAL ecg4_responseReady( void ) - Function returns 1 when response is ready for reading, or 0 if is not ready.

Examples Description

The application is composed of three sections :

• System Initialization - Initializes peripherals and pins.
• Application Initialization - Initializes UART interface, performs a reset of the device and powers up control of Low Drop Out (LDO).
• Application Task - (code snippet) - Always checks does response ready and, when is ready, processes a response. Note : The Sound library is used to play sound on buzzer every time when R interval on the ECG signal happened. The Sound Play command can make a delay time which is necessary for play command to be performed. If you don't need to make sound on buzzer, please disable the Sound Init and Sound Play functions.

void applicationTask()
{
    resp_ready = ecg4_responseReady();
    
    if (resp_ready == _ECG4_RESPONSE_READY)
    {
        processResponse();
    }
}

Additional Functions :

• interrupt - Always checks does new data ready for reading from uart rx buffer, and if is it true reads one byte data from uart and makes a response sequence.
• plotData - Sends a desired data (Raw Data) to the serial plotter.
• logData - Sends data to the uart terminal and shows results.
• makeResponse - Pars a response to the buffer.
• processResponse - Processes a parsed response and makes a decide where response will be showed.

The full application code, and ready to use projects can be found on our LibStock page.

Other mikroE Libraries used in the example:

• Conversions
• Sound
• UART

Additional notes and informations

Depending on the development board you are using, you may need USB UART click, USB UART 2 Click or RS232 Click to connect to your PC, for development systems with no UART to USB interface available on the board. The terminal available in all Mikroelektronika compilers, or any other terminal application of your choice, can be used to read the message.

---

---