miata-bot / daveecu2 Goto Github PK

Your VRef+ is 3V3, your VPROT is 5V, you may want to change VRef+ to 5V

@ConnorRigby Just having a look now. Guessing it's still a WIP? The injector sheet for eg isn't done
on the ignition sheet, the 10k resistors should be 10 Ohm
Everything else looks mostly like it's the same as my NA circuits, so should be OK
A couple of changes that I've done on newer board revisions....

• The diode on the idle out (D5), put them on the boost and VVT outputs too
• On the MC33814 sheet, insert a polyfuse (500mA to 1A) between pin 20 on the 33814 and the VPROT tag
• As you've got the 2560 directly on the board, you'll want a momentary contact switch on the reset line to make life easier getting the bootloader on there

If you can do a pulldown in the MCU (40k ohm iirc), do you still need those 100k ones on those circuits?

3A peak current is prolly fine for stock coils, but i.e. R8 Red Tops pull horrendous 8A while charging, may be worthwhile to replace that with a higher current driver.