MrPlate, a play on word on "My Stir Plate", is a project to build a neat advanced stir plate that is frankly overkilled for most uses.
My goal is the following:
- To have exact control over rotation speed
- Have a full display to communicate with users
- Heating is out-of-scope
This project might move to a higher-level language such as Rust (zinc) or Go? :D but should still remain on a pretty low cost* board (such as a Teensy).
Contributions to this project are welcome, however since the goal will be to support specific hardware version, it is not yet clear to me how this will be done.
Maxime Lavigne
How to build/run (either through Visual Studio 17, or CLion, but must use VS toolchain.)
- Regen CMake
- Run MrEmulator.exe