m1cha / esp32_tcpbug

TCP Server example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

The application creates a TCP socket with the specified port number and waits for a connection request from the client. After accepting a request from the client, connection between server and client is established and the application waits for some data to be received from the client. Received data are printed as ASCII text and retransmitted back to the client.

How to use example

In order to create TCP client that communicates with TCP server example, choose one of the following options.

There are many host-side tools which can be used to interact with the UDP/TCP server/client. One command line tool is netcat which can send and receive many kinds of packets. Note: please replace 192.168.0.167 3333 with desired IPV4/IPV6 address (displayed in monitor console) and port number in the following command.

In addition to those tools, simple Python scripts can be found under sockets/scripts directory. Every script is designed to interact with one of the examples.

TCP client using netcat

nc 192.168.0.167 3333

Python scripts

Script tcpclient.py contains configuration for port number, IP version (IPv4 or IPv6) and IP address that has to be altered to match the values used by the application. Example:

PORT = 3333;
IP_VERSION = 'IPv4'
IPV4 = '192.168.0.167'
IPV6 = 'FE80::32AE:A4FF:FE80:5288'

Hardware Required

This example can be run on any commonly available ESP32 development board.

Configure the project

make menuconfig

Set following parameter under Serial Flasher Options:

• Set Default serial port.

Set following parameters under Example Configuration Options:

• Set WiFi SSID of the Router (Access-Point).

• Set WiFi Password of the Router (Access-Point).

• Set IP version of the example to be IPV4 or IPV6.

• Set Port number of the socket, that server example will create.

Build and Flash

Build the project and flash it to the board, then run monitor tool to view serial output:

make -j4 flash monitor

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Troubleshooting

Start server first, to receive data sent from the client (application).