listofoptions / th-xwhatsit Goto Github PK

Hi List.

I have a TH controller for my Displaywriter. What do I need to do to enable the speaker to function? I have a solenoid driver as well if that's necessary. Please advise.

Thanks!

Would have done a pull request, but kicad library management was driving me nuts.

As model F AT has soldered ribbon cable with 3.96mm pitch, add optional pads, connected 1-to-1 to existing plugboard connector. Positioning is important in horizontal direction as AT case has molded screw mount near there. The distance from the edge of the board to edge of pads shoult no exceed 16mm. See the attached screenshot.

Also, the ground strap connector hole is annoyingly small, dealing with 2mm screws and standoffs is just painful. Maybe increase the hole size from 2.2mm to 3.5.