kailash-natarajan / raspberry-pi-camera-video-streaming-60-fps-http

Provides Live Streaming of Raspberry Pi Camera using Raspberry Pi at 60 FPS over HTTP URL within the same network.

Pi-Camera-HTTP-Video-Streaming

This procedure allows live streaming of Raspberry Pi Camera within the same network at 720p resolution with 60 FPS.

• This method allows Raspberry Pi to broadcast the Raspberry Pi 5MP Camera Module's video feed on a HTTP URL within the same network and does not need additional softwares like VLC Player to access the video feed. The HTTP URL can be accessed from a Web Browser.
• To get video stream on HTTP, the simplest method is to configure Motion serivce on the Raspberry Pi. But this Motion service runs a motion detection feature on the video stream by default and gets defaulted to 1 FPS when no motion is detected (which is a useful for applications like CCTV cameras). The procedure described below is for getting maximum performance at minimum lag from the camera over the network, so we will disable the motion detection feature.

• By default the video is broadcast in colour format. But to reduce bandwidth requirement, we use greyscale mode, although 720p 60FPS is possible on colour mode also.

• Note: This was tested on Raspberry Pi 4 and Raspberry Pi 5MP Camera Module with Raspberry Pi OS. Other combinations have not been tested.

Pre-Requisites:

• Raspberry Pi should already be setup completely (including SSH if required) and must be connected to a network.
• Remove existing installation of Motion (if any).

Setup (on the Raspberry Pi). Run the following commands on the terminal of Raspberry Pi

Step 1: Navigate to any personal folder (optional).

Step 2: Run the following commands one by one:

$ sudo apt-get install autoconf automake autopoint build-essential pkgconf libtool libzip-dev libjpeg-dev git libavformat-dev libavcodec-dev libavutil-dev libswscale-dev libavdevice-dev libwebp-dev gettext libmicrohttpd-dev

$ sudo mkdir motion

$ cd motion

$ sudo git clone https://github.com/Motion-Project/motion.git

$ cd motion

$ sudo autoreconf -fiv

$ sudo ./configure

$ sudo make

$ sudo make install

$ cd /usr/local/etc/motion

$ sudo wget -L https://raw.githubusercontent.com/Kailash-Natarajan/Raspberry-Pi-Camera-Video-Streaming-60-FPS-HTTP/main/motion_720p60.conf

$ sudo mv motion_720p60.conf motion.conf

Starting Motion Service for broadcasting

$ motion

Stopping Motion Service

Press Ctrl+C in the same terminal where Motion was started.

Start the Motion service and type the URL of the format http://<rpi_ip>:8081 in your web browser to access the video feed, where <rpi_ip> is the local network IP address of the Raspberry Pi. You should be getting 720p 60FPS video at greyscale.

This video feed can also be accessed by OpenCV using the same URL, thus allowing for use of image processing techniques too.

Note: This may not work if you just replace the motion.conf file for your existing installation of Motion

Official Installation Instructions