PCB form Megadrive/Genesis 2 RGB minidin to Scart adapter with 12V DCDC boost (4:3 switching)
When we plug a Megadrive 2 console via scart on the "newer" CRT TVs as the minidin provides 5v on the console side the tv will switch to AV with a 16:9 aspect ratio. We need to deliver between 9v to 12v on the swtiching side to output directly to AV with 4:3 aspect ratio.
This is intended to be a PCB using the default Megadrive/Genesis 2 RGB cable schematic but adding the 12v DC-DC switching boost on the scart side from the 5v supplied by the MD2.
This board intends to provide a standard Sega Megadrive 2 RGB cable (Sega Genesis).
In the BOM directory there's an interactive BOM with all the required components.
In the gerbers directory we have the gerbers to manufacture the boards.
In the KiCAD folder we can find the KiCAD project itself.
You can find a copy on PDF on the root of the repository.
1- Send to manufacture the GERBER board to JLCPCB or other PCB manufacturer.
2- Get the components required, you can see here the Bill Of Materials BOM
3- Solder the wire to each of the pads and to the scart male.
4- Remember to solder the shield of the scart to the GND as well to avoid noise issues.
At this stage you should have something like this:
Of course you can always try to solder the minidin 9 connectors from Aliexpress, good luck with that!
(You will need good flux and scratch the surface - some of them are almost imposible)
But my recommendation is to buy these ones:
1- RS 75ohm cable with shield: RS Spain link code 724-1150
2- Minidin 9 male to male cable: Aliexpress 3m male to male with shield
And yes, read below, no responsibility taken on bad use.
See LICENSE for more information.
React
Typescript
Django
Laravel
Facebook
Microsoft
Google
Alibaba
D3
Tencent