Requirements:
- PWM Fan on Pin 18 on Raspberry Pi 3
- 1-wire Temperature Control
- IFFT Account
Installation:
- Install RPIO
- sudo apt-get install python-setuptools
- sudo easy_install -U RPIO
For Therm:
- Check /boot/config.txt
- Add line at bottom
- dtoverlay=w1-gpio,gpiopin=17
- Orange Stripe = VCC, White = Ground, Blue Stripe = Pull-up output
- Run test_therm.py
For Display:
- Connect up pins 3 and 5 for i2c
- run sudo raspi-config, go to intefaces, i2c, enable loading of modules
- pip install Adafruit-SSD1306
- Go get the newest version using wget wget https://raw.githubusercontent.com/adafruit/Adafruit_Python_SSD1306/master/Adafruit_SSD1306/SSD1306.py
- Cp SDD1306.py /usr/local/lib/python2.7/dist-utils/Adafruit-SSD1306
- run test_disp.py
For wifi:
- sudo pip install wifi