AIM:
To implement JK flipflop using verilog and validating their functionality using their functional tables
SOFTWARE REQUIRED:
Quartus prime
THEORY
JK Flip-Flop
JK flip-flop is the modified version of SR flip-flop. It operates with only positive clock transitions or negative clock transitions. The circuit diagram of JK flip-flop is shown in the following figure.
This circuit has two inputs J & K and two outputs Qtt & Qtt’. The operation of JK flip-flop is similar to SR flip-flop. Here, we considered the inputs of SR flip-flop as S = J Qtt’ and R = KQtt in order to utilize the modified SR flip-flop for 4 combinations of inputs. The following table shows the state table of JK flip-flop.
Here, Qtt & Qt+1t+1 are present state & next state respectively. So, JK flip-flop can be used for one of these four functions such as Hold, Reset, Set & Complement of present state based on the input conditions, when positive transition of clock signal is applied. The following table shows the characteristic table of JK flip-flop. Present Inputs Present State Next State
By using three variable K-Map, we can get the simplified expression for next state, Qt+1t+1. Three variable K-Map for next state, Qt+1t+1 is shown in the following figure.
The maximum possible groupings of adjacent ones are already shown in the figure. Therefore, the simplified expression for next state Qt+1t+1 is Q(t+1)=JQ(t)′+K′Q(t)Q(t+1)=JQ(t)′+K′Q(t)
Procedure
step-1 Go to quartus software.
step-2 Set new environment.
step-3 Type the code to implement SR flipflop using verilog and validating their functionality using their functional tables.
step-4 Run the program.
step-5 Give inputs in the waveform table .
step-6 Run the program.
PROGRAM
/* Program for flipflops and verify its truth table in quartus using Verilog programming.
Developed by: JIDHESH P
RegisterNumber:212223040078
*/
module JKFLIPFLOP(q, qb,j,k,clock,reset);
input j,k,clock,reset;
output reg q, qb;
always @ (posedge (clock))
begin
if (!reset)
begin
q <= q;
qb <=qb;
end
else
begin
if(j==0 && k==0)
begin
q<=q;
qb<=qb;
end
else if(j!=k)
begin
q<=j;
qb<=k;
end
else if(j==1 && k==1)
begin
q<=~q;
qb<=~qb;
end
end
end
endmodule
RTL LOGIC FOR FLIPFLOPS
TIMING DIGRAMS FOR FLIP FLOPS
RESULTS
Thus,the code executed successfully.