SDRAM Tester FPGA

This repository contains a source code of the SDRAM Tester implemented in FPGA. The SDRAM tester generates writes and reads to random or sequential addresses, checks the read data, and measures throughput. The project was created during the European FPGA Developer Contests 2020.

Development board CYC1000 with W9864G6JT SDRAM chip, documentation, driver
Languages - VHDL, Python

The project is using the following open-source codes:

https://github.com/nullobject/sdram-fpga - The simple SDRAM controller by Josh Bassett
https://github.com/zhelnio/ahb_lite_sdram - The SDRAM controller for MIPSfpga+ system by Stanislav Zhelnio

To clone the repository, run:

git clone --recursive [email protected]:jakubcabal/sdram-tester-fpga.git

A short demonstration video can be found on YouTube here.

FPGA design

Parameters (Top level generics)

Name	Type	Default	Generic description
SDRAM_CTRL_SEL	natural	0	SDRAM controller selection: 0 = sdram-fpga by Josh Bassett (nullobject), 1 = ahb_lite_sdram by Stanislav Zhelnio (zhelnio).

Top level diagram

         +----+----+
UART <---| UART2WB |
PORT --->| MASTER  |
         +---------+
              ↕
      +=======+======+ WISHBONE BUS
      ↕              ↕
 +----+----+    +----+----+
 | SDRAM   |    | SYSTEM  |
 | TESTER  |    | MODULE  |
 +---------+    +---------+
      ↕
      + ---> LEDs
      ↕
 +----+----+ 
 | SDRAM   | 
 | CTRL    | 
 +----+----+
      ↕
    SDRAM

Main modules description

UART2WB MASTER - Transmits the Wishbone requests and responses via UART interface (Wishbone master).
SYSTEM MODULE - Basic system control and status registers (version, debug space etc.).
SDRAM TESTER - Read and write request generator for SDRAM controller, checking read data.
SDRAM CTRL - Selected SDRAM controller.

Resource usage of the whole design:

SDRAM_CTRL_SEL	LE	FF	BRAM (M9k)	Fmax
0 (sdram-fpga)	902	650	0	111.7 MHz
1 (ahb_lite_sdram)	1071	703	0	124.6 MHz

Implementation was performed using Quartus Prime Lite Edition 20.1.0 for FPGA Intel Cyclone 10 LP 10CL025YU256C8G.

SDRAM tests:

How to run tests:

Connect the CYC1000 board to the PC with a USB cable.
Upload to FPGA design with SDRAM Tester.
Run Python script (PySerial is required):

python .\sw\run_tests.py

Measured throughput:

SDRAM_CTRL_SEL	SEQ WR	SEQ RD	RAND WR	RAND RD
0 (sdram-fpga)	398.46 Mbps	531.27 Mbps	398.46 Mbps	531.27 Mbps
1 (ahb_lite_sdram)	318.32 Mbps	265.27 Mbps	318.32 Mbps	265.27 Mbps

Tests was performed using selected SDRAM controller running at 100 MHz with configuration: CAS latency = 2, Burst length = 2.

License

The project is available under the MIT license (MIT). Please read LICENSE file.

jakubcabal / sdram-tester-fpga Goto Github PK