graphmatic / elektron-models-sample-solo-mode---logic-pro-environment Goto Github PK

There is a Logic Pro X environment that make MUTE buttons on ELEKTRON MODELS:SAMPLE to act as SOLO buttons. Radio mode only.

    Open project with LOGIC PRO, setup the M:S so Track 1 respond to MIDI channel 1, track 2 to MIDI channel 2 and so on.
    As I’ve not found other solution to switch the SOLO mode ON/OFF from the M:S interface, the FADE setting of LFO (in LFO SETUP menu) of Track 1 is used:
    O value disable SOLO Mode (PADs act normal MUTE)
    1 value activate the SOLO Mode

To use another CC to switch the mode on/off (if you have a spare button on another MIDI control surface), open the Environment window of Logic and choose the layer called “M:S SOLO MODE”. On the left, find the cable selector labeled “SETUP SOLO MODE ON/OFF CC” and configure it as you need.
Near this cable selector, a transformer module allow to remap CC’s range if needed.
You may have to connect the M:S pin of Logic “physical input” module to the monitor module just below. The module that you may need to edit are linked with green cables.
I added a screen capture to make it more clear.

PADs LEDs on the Models:Sample are accurate.
It should work with Model:Cycles too, as MIDI implementation for MUTE are the same.


The template also provide an easy to use interface that allow to access 3 more LFO reset modes (Sample & Hold, One cycle and Half cycle), only available on the M:S control surface from Velocity Modulation. So, you will be able to P.lock this lfo retrigger modes or to use them without requiring Velocity modulation to be activated...


To:Do:
 - Tested using the USB port of M:S only, should work with DIN MIDI ports, but MIDI loop may happen if M:S MIDI OUT is set to THRU ...(?)

Limitation: When using "Play Note", if you sequentially press one LFO-mode button then another one, the LFO-mode change resp. To the second selection will only happen after the note event, meaning the first note will be played with the LFO-mode previously selected. From Logic, the note event is send before the CC and so it's not possible to solve that: the note seems to be prioritised over CCs in the M:S ...