gladys-milight's Introduction

WARNING : this is a WIP to add v6 compatibility. (upgrade to node-milight-promise v0.2.3)

What works for now (18/08/2017) :

Detection of all kinds of bridges : Depending on its version, the bridge will have an identifier "IP_ADDRESS:v6" or "IP_ADDRESS:legacy" in Gladys.
Full control of RGBW and RGB-CCT lamps on V6 bridge ( on/off, brightness, saturation and hue, whiteMode and nightMode). To allow this control you need to add for your device the following deviceTypes (see the picture for the available ranges):

binary brightness saturation hue whitemode nightmode

Full control of Bridge Leds (if any). Create a Device with "BRIDGE_ID:bridge" as identifier to control it, with the same DeviceTypes as for lamps (except saturation, which can't be controlled).

Gladys Milight

This module allows you to control your milight lamps in Gladys.

To install this module :

Install the module in Gladys
Reboot Gladys
Go on the dashboard on "Module" view, then in the module list press the "config" button on the milight module.
Your milight bridge should appear in the "Device" view. If not, you can press config again. Note the ID of the bridge device.
Create a device for each Milight lamp you want to control with the following parameters: identifier: BRIDGE_ID_IN_GLADYS:MILIGHT_ZONE, protocol: rf, service: milight. Note that the protocol here is important. Here is an example of a lamp in Zone 1 with bridge ID 12 : {identifier: 12:1}
Create foreach device these three deviceTypes :

Recommend Projects