fakedazon / lily58-stacked-case

Lily58-Case

A simple stacked case design for the Lily58. Cut as many middle parts that you need. This case was designed to use M2 screws and standoffs. for each case, you need 5 standoffs and 10 screws. PLEASE NOTE THAT THIS HAS NOT BEEN TESTED, AND MAY NOT FIT PROPERLY.

What the case looks like:

Building the case

Put the switches in the top plate, solder them / put them into the pcb. Put the standoffs into the two middle pieces (bigger screw holes), with the piece with a hole in the top on top. Screw the top plate into the top piece (with the top hole), and the bottom plate into the bottom piece. boom bam bop youre done!

Cutting with Ponoko

If you want to cut this case with a service like Ponoko, start by downloading the Lily58-Case.ai file. Then go to Ponoko.com and upload the .ai file.

On the Design screen, select Confirm design & colors and dimensions are correct.

Next, on the materials screen, choose plastic, and select any acrylic option. After selecting, ensure that the thickness is .12 inches.

Finally, on the Price screen change the quantity to 2, for the two halves of the lily. Add this to your cart, pay, and wait!

You will need to buy M2 standoffs and screws. I suggest buying M2X6mm standoffs from here and M2x6mm screws from here.