Not working with latest firmware (9.1.0) about sysdvr

[paprika714]

Thank you really much for the answer, I solved the problem.
Actually I did have hekate 5.1.0 and didn't notice that a new versione came out in the last hours so I updated it and looks like that the console doesn't get stuck while booting anymore.

I also solved the issue with the usb ID, i had to switch in the configuration. Sorry I didn't read it properly.

Again, thank you so much.

[exelix11]

Just tested and can confirm it works as expected on my 9.1.0 console.
Does the 9.1.0 switch have other sysmodules ? If so it could be a memory issue. Also make sure to be using latest atmosphere (0.10.1) and hekate (5.1.1, assuming you're using it) versions as they free some extra memory for sysmodules.
About usb you're supposed to install the drivers only after the 3006 device shows up, by default SysDVR launches in network mode, you have to use the config homebrew to enable USB mode, please read carefully the guide.

[hunkh]

la identificación del usb no es la correcta (aún aparece 2000 en lugar de 3006, incluso después de instalar los controladores con Zadig).como resolver este problema