FreeCAD Tube Winder

The tube winder is suitable for (PE) water tubes having a diameter up to approx. 40mm. The winder should be used by two people for smaller tubes and three people for larger tubes.

Parts

Quantity	Type	Label	Description
4	AP3030S8	42,00 mm
4	AP3030S8	400,00 mm
4	AP3030S8	427,46 mm
2	AP3030S8	450,00 mm
4	AP3030S8	560,00 mm
2	AP3030S8	1150,00 mm
8	AP3030S8_AngleConnector45
15	AP3030S8_BracketSmall
16	AP3030S8_Cap
2	AP3030S8_ConnectorSquare
9	AP3030S8_InnerBracketWithScrews		Inner bracket usually shipped including two set screws.
2	AP3030S8_Joint
39	AP3030S8_StoneM6Heavy
22	AP3030S8_StoneM8Heavy
1	AP3030S8_TNutM6
6	KnuckleFoot_M8x50
1	Nomis_C-Clamp_WithMod		Spigot removed. Two additional 6,5mm holes need to be drilled. Availble via Amazon or ebay, look for "NOMIS C-Klemme mit Spigot".
1	Screw/Bolt ISO4762	M6x12
4	Screw/Bolt ISO4762	M8x25
8	Screw/Bolt ISO7380-1	M8x12
8	Screw/Bolt ISO7380-1	M8x25
39	Screw/Bolt ISO7380-2	M6x12
8	Screw/Bolt ISO7380-2	M8x10
1	SwivelPlate_WeihuaC16049_156x156		Hole with diameter 8,5mm-9mm (M8) needs to be drilled at end of slot holes. Available via Amazon, search for "Drehteller für TDS Bootssitz".

Compatibility

Prerelease builds of FreeCAD have been used to create the models. Therefore, incompatibilities with older or newer FreeCAD builds might occur. The following software builds haven been used and are known to be compatible:

Partial loading of linked files should be disabled. If not, some files need to be reloaded manually to fix some glitches.

Content created with the TechDraw workbench might seem broken (content shifted out of the drawing area) when first viewed after loading the file. If so, switch to 3D view and then back to the TechDraw content or right click the TechDraw document in tree view to fix the layout issues.

Before commiting to this repository, _setup.sh should be run to setup a git smudge filter, that decompresses FCStd files during commit: FCStd files are zip compressed archives of mostly xml formatted plaintext files. Git's delta compression works very well for xml files, but not if compressed. For security reasons, the filter needs to be configured explicitly. Therefore, it cannot be shared in a way that does need user interaction. Decompressing is done using compression level store which preserves full FreeCAD compatibility. A clean filter is not used, therefore files in working tree are slightly bigger after checkout compared with the initial file size.

episource / freecad-tubewinder Goto Github PK