See if Seer can support the cuda-gdb debugger. about seer

[epasveer]

Here's my build commands. Note, it points to the cuda-12.3 installation directory that you should have built earlier. It has the missing header file. Later cuda releases should change "12.3" to the new version.

$ ./configure --program-prefix=cuda- \
    --prefix=/usr/local/cuda \
    --enable-cuda \
    --enable-targets="x86_64-unknown-linux-gnu,arm-elf-linux-gnu,m68k-unknown-linux-gnu" \
    CFLAGS="-I/usr/local/cuda-12.3/extras/Debugger/include/ -I/usr/local/cuda-12.3/include" \
    CXXFLAGS="-I/usr/local/cuda-12.3/extras/Debugger/include/ -I/usr/local/cuda-12.3/include" \
    LDFLAGS='-lpthread'

$ make all-gdb
$ sudo make install

[epasveer]

These are better instructions. It creates and installs the cuda-gdbserver as well.

$ ./configure --program-prefix=cuda- \
    --prefix=/usr/local/cuda \
    --enable-cuda \
    --enable-targets="x86_64-unknown-linux-gnu,arm-elf-linux-gnu,m68k-unknown-linux-gnu" \
    CFLAGS="-I/usr/local/cuda-12.4/extras/Debugger/include/ -I/usr/local/cuda-12.4/include" \
    CXXFLAGS="-I/usr/local/cuda-12.4/extras/Debugger/include/ -I/usr/local/cuda-12.4/include" \
    LDFLAGS='-lpthread'

$ make all-gdb all-gdbserver
$ sudo make install-gdb install-gdbserver