enduif / mariner

Web interface for controlling MSLA 3D Printers based on Chitu controllers, such as the ones by Elegoo and Phrozen.

If you are not running Firmware 4.4.3, then DO NOT install Mariner from this fork. It is unlikely to work.

🛰️ mariner (BlueFinBima Fork)

Web interface for controlling MSLA 3D Printers based on ChiTu controllers remotely. This fork is to allow Mariner to work with Firmware 4.4.3 which had to be installed in order to allow ChitBox 1.9 sliced files to be printed. It was found that Mariner did not work with this Firmware level because a number of the commands stopped working.

The issue with 4.4.3 was raised as luizribeiro#453

Features

• Web interface with support for both desktop and mobile.
• Upload files to be printed through the web UI over WiFi!
• Remotely check print status: progress, current layer, time left.
• Remotely control the printer: start prints, pause/resume and stop.
• Browse files available for printing.
• Inspect .ctb files: image preview, print time and slicing settings.

For more details on the feature set, refer to our Documentation.

Supported Printers

Mariner supports a wide range of MSLA printers, including printers from the following manufacturers:

• Anycubic
• Creality
• EPAX
• Elegoo
• Peopoly
• Phrozen
• Voxelab

Please refer to the list of Supported Printers on our documentation for a full list of printer models that have been tested. If you have access to other printers and want to contribute, please open an issue. We're happy to support more printers!

Documentation

The documentation is available from Read the Docs. It contains a lot of information from how to setup the hardware, install the software, troubleshoot issues, and how to contribute to development.

This blog post explains the setup end to end with pictures of the modifications done to an Elegoo Mars Pro.