egefeyzioglu / diy-pid-soldering-station

Soldering Iron/Heat Gun Controller

DIY-PID-Soldering-Station

Soldering Iron/Heat Gun Controller

To do:

General

• Fix Issue with Having Encoder to Adjust (not enough interrupts, mostly related to AVR and PIC)
• Fix the shunt resistor placement
• Fix the PWM pins
• Remove External x-tall (Atmega8 - can also change to 8mhz value but personally don't see point.)
• Also Fix Versioning

[x] (AVR) Standalone Schematics

• Temperature NTCs
• Stand Idling Interrupt
• ICSP Header for programming
• Board Layout

===========================================

[ ] (AVR) Arduino Schematics

• Temprature NTCs
• Stand Idling Interrupt
• Shield Layout

===========================================

[ ] (AVR) Arduino Code

• PID Algorithm
• I2C Character Display
• PID Calibration
• PID Double Config (More aggressive PID at low temps)
• Menu Function
• PID Auto Calibration Algorithm
• Power Calculation (Shunt Resistor)
• Support for 2nd equipment (potentially objective for PID)

===========================================

[ ] (AVR) Atmel Studio Code

• PID Algorithm
• I2C Character Display
• PID Calibration
• PID Double Config (More aggressive PID at low temps)
• Menu Function
• PID Auto Calibration Algorithm
• Power Calculation (Shunt Resistor)
• Support for 2nd equipment (potentially objective for PID)

===========================================

[ ] (PIC) Eagle Schematics

No Versions Yet

===========================================

[ ] (PIC) Proteus Simulation

No Versions Yet

===========================================

[ ] (PIC) MPLab Code

No Versions Yet

===========================================

[ ] (ESP) ESP32 Schematics

- [ ] Module Based

No Versions Yet

- [ ] DevKitC Based

No Versions Yet

===========================================

[ ] (ESP) ESP32 Code

No Versions Yet