dodubassman / duckfoot-rev3

DuckFoot-rev3

Duckfoot is a low profile Corne-inspired split keyboard, powered by Nice!Nano. With a pair of EVQWGD001 roller encoders.

PCB

Kicab files made with ergogen.

Switches footprint is Kailh Choc V1, supporting hotswap socket or direct soldering (I wouldnt do that if I were you).

You'll also need:

• MSK12C02 on/off switch
• Reset micro tactil switch
• a bunch of smd diodes
• 90mAh batteries. You can chose bigger capacity, but honestly with no LEDs on the board, you won't need more. I chose direct soldering for batteries because JST sockets are to big and a nightmare to wire.

The board is reversible, so one minimal order on PCBWay or JLCPCB gives you 2.5 keyboard and a seconde chance if you suck at soldering.

Reversible means left Nice!Nano has to be soldered upside down. If you're lost, pins are idendified on the printed silk layer of the pcb (at least RAW, GND, RST, VCC).

Plate and case

Soon.

Config

Net matrix

Querty example (promicro)

	P2	P3	P4	P7	P8	P10
P1	tab	Q	W	E	R	T
P20	Shift	A	S	D	F	G
P19	Ctrl	Z	X	C	V	B
P9			rollclik	thumb	thumb	thumb

ZMK Config example

Licence

DWTFYWT Public Licence.