diyofthings / bambulab_esp32_ledcontroller

Bambulab Status Indicator and Web Controller based on ESP32. Provides OBS Overlay.

Bambulab Esp32 LEDController

Quick getting started - for more details check this WIKI!

Click here to get to the flasher.

The ESP32 is flashed with the firmware.

The ESP32 is now building a W-Lan access point with which we connect. The current password is: password

After that we have to navigate to the Wifimanager Config page with a browser. The IP is: 192.168.4.1

There you enter your W-Lan registration data.

Optionally, the Bambulab printer can be set up now or you can set it up later via the serial console or via the website.

If the EPS32 is connected to the WiFi, you should be able to find and reach it in your network. The IP of the device is also output via the console if a programming app is installed.

As soon as you enter the IP of the EPS32 in your browser, you will get to the welcome page. On the right side of the navigation you get to the configuration.

If the printer is not already connected, it reboots once after saving the data and it should connect to the MQTT.

The 3D Files are at Printables, click here!

Hardware Infos

For a list of working ESP32 Controllers see release.

Pin 16 is connected with WS2812B Data Pin.

OBS Stream Overlay

Just add your device ip/obs as webpage to OBS. If you want to change something you need to edit the obs file in src directory and self compile.

For more infos and help see my discord at: http://discord.vr6syncro.de

License

This project is licensed under the "Attribution-NonCommercial-ShareAlike 4.0 International" License. See the LICENSE file for more details.