diveflo / ping2mqtt

Deliver host latency information over mqtt.

ping2mqtt - Deliver latency information over mqtt.

This program will continuously ping one or more hosts and report stats every 10 seconds. It keeps a rolling 10 second, 1 minute, and 5 minute average. It publishes Home Assistant MQTT autodiscovery information so that you can access this data from HA.

Running

Use docker to launch this. A typical invocation is:

docker run --network mqtt -e MQTT_HOST=mosquitto -e HOSTLIST=localhost:127.0.0.1,router.local:192.168.1.1,internet.gw:10.10.10.1 skullydazed/ping2mqtt

You can also use docker compose:

version: '3'
services:
  ping2mqtt:
    container_name: ping2mqtt
    image: skullydazed/ping2mqtt
    environment:
    - HOMEASSISTANT_PREFIX=homeassistant
    - HOSTLIST=router.local:192.168.1.1,internet.gw:10.10.10.1
    - MQTT_CLIENT_ID=ping2mqtt
    - MQTT_USER=username
    - MQTT_PASSWD=password
    - MQTT_HOST=mosquitto
    - MQTT_PORT=1883
    - MQTT_TIMEOUT=300
    - MQTT_TOPIC_PREFIX=ping
    - MQTT_QOS=1
    restart: always

Configuration

You can use environment variables to control the behavior.

Variable	Default	Description
DEBUG		Set to 1 to enable additional debug logging.
HOMEASSISTANT_PREFIX	homeassistant	The prefix for Home Assistant discovery. Must be the same as discovery_prefix in your Home Assistant configuration.
HOSTLIST	localhost:127.0.0.1	A comma separated list of hosts to ping. This is the valid grammar for each host entry: <hostname[:ip_address]>
MQTT_CLIENT_ID	mqtt2discord	The client id to send to the MQTT broker.
MQTT_USER	``	The user to send to the MQTT broker. Leave unset to disable authentication.
MQTT_PASSWD	``	The password to send to the MQTT broker. Leave unset to disable authentication.
MQTT_HOST	localhost	The MQTT broker to connect to.
MQTT_PORT	1883	The port on the broker to connect to.
MQTT_TIMEOUT	300	The timeout for the MQTT connection.
MQTT_TOPIC_PREFIX	ping	The MQTT topic prefix. With the default data will be published to ping/<hostname>.
MQTT_QOS	1	The MQTT QOS level

Consuming The Data

Data is published to the topic ping/<hostname> using JSON serialization. It will arrive every ~10 seconds in the following form:

{
    "alive": "on",
    "last_10_sec": {"min": 8.175, "avg": 32.592, "max": 136.915, "percent_dropped": 0.0},
    "last_1_min": {"min": 7.202, "avg": 25.959166666666665, "max": 23.103, "percent_dropped": 1.6666666666666714},
    "last_5_min": {"min": 6.87, "avg": 49.44593333333333, "max": 23.103, "percent_dropped": 2.0}
}

• alive: Set to on when the host is up, otherwise off
• last_10_seconds: An average of the last 10 datapoints we received
• last_1_min: An average of the last 6 last_10_seconds averages
• last_5_min: An average of the last 30 last_10_seconds averages

Home Assistant

After you start the service binary sensors should show up in Home Assistant pretty immediately. Look for sensors that start with binary_sensor.ping. The latency information will be available as attributes, which you can then expose using template sensors if you wish. Be aware that the attributes are updated every 10 seconds, you will quickly fill your history db if you do not exclude your template sensors.