crispy1279 / smoothie

Smoothieware for Micromake D1

Smoothieware for Micromake D1

#Remember to change the jumper on the board to 1/32 microstepping

###Features: Hotend fan turns on/off at 50 Degrees C.
Works with standard Micromake Probe.

Pinout info:
http://forums.reprap.org/file.php?13,file=77370,filename=pcb-overview-compressed.jpg

Pronterface can connect to Smoothie over the network by using telnet
just enter ip_of_smoothie:23instead of the serial port before clicking 'Connect'.

Delta calibration and grid levling

M561; clears the grid and turns off compensation
M280 S3.0; Pin down
G32; Probes the three probe points and defines the bed plane, this will remain in effect until reset or M561
M500; Saves the probe points and the probe offsets
G31; probes the grid and turns the compensation on, this will remain in effect until reset or M561/M370 optional parameters Jn sets the radius for this prob
G28; Go Home
G0 Z0; Then move to the point the machine currently thinks is Z 0
; Then move the head to the bed by jogging, using Pronterface's arrows, the panel or the web interface.
M306 Z0; Save new z height
M374; Saves the grid to a file on the SD card (ZGrid).
M500; Saves the probe settings
M280 S7.0; pin up

BLTouch commands

M280 S3.0; Pin down
M280 S7.0; pin up
M280 S5.5 zpin test mode
M280 S8.4 self test
M280 S10.6 Alarm release