cpq / xmc1100

Baremetal firmware for xmc1100 2Go devboard

This firmware implements a simple blinky on an Infineon XMC1100 2Go development board, based on a 32Mhz Cortex-M0 MCU with 16k RAM, 64k flash, and some peripherals including WDT, RTC, PRNG, USIC (serial: SPI, I2C, UART), ADC, GPIO and a temperature sensor. The data sheet available from the Infineon website.

xmc1100 2Go devboard

This little development board has a built-in j-link compatible debugger, which makes it easy to program and debug using Segger j-link software. It has 2 on-board LEDs, attached to P1.0 and P1.1 (in the source code, those are pins B0 and B1). Both pins are red.

Software Requirements

• ARM GCC, https://launchpad.net/gcc-arm-embedded
• GNU make, http://www.gnu.org/software/make/
• J-Link software, http://www.segger.com/jlink-software.html

Build and flash

$ make build flash