corygrant / canboard_fw Goto Github PK

Hi guys,

Would it be possible for these to be configured to emulate the 2 Haltech IO Box 12's? I've got CAN data for the TX side from Haltech themselves.

Their box has 4 x AVI's, 4 x DPO's, and 4 x DPI's. Obviously I'd only be able to use the inputs as I haven't got the RX data from them, but I doubt it would be too hard to work out.

Not really an issue, but do you have infos on hardware used, and the howto to flash the firmware?

Would firmware update over CAN be desirable?

Any chance to compile firmware from command line?

github has a feature to host official binaries any chance for any official binary?

https://docs.github.com/en/repositories/releasing-projects-on-github/managing-releases-in-a-repository

I see https://github.com/corygrant/CANBoard_FW/tree/main/Middlewares/Third_Party/FreeRTOS should it be using https://github.com/freertos as a git submodule?

• Each devices uses four addresses BASE,BASE+1.. BASE+3
• jumpers allow four consecutive options

Those two together mean there is no way to configure for two units on same network?

https://github.com/corygrant/CANBoard_HW#jumpers

i see no Makefile :(

I see some Eclipse-based IDE any chance to spell out what IDEA this is? is that mxcube? any specific version known to open this project mxcube?

seeing that a lot of code was done two years ago can you mention which GCC is known to work for this source code? i know there are minor nasty differences between 9, 10, 11 and 12

What is the license for this firmware?

https://docs.github.com/en/repositories/managing-your-repositorys-settings-and-features/customizing-your-repository/licensing-a-repository