Compatibility with Adafruit RFM95W? about dragino

[BNNorman]

Sorry to see no-one has replied to this, so here goes.

The Dragino I have has a Hope RFM95 pcb soldered on it so it should work. The W postfix simply means Worldwide distribution IIRC.

You should check the Dragino schematic to see what RPi pin/wiring is used.

The keyerror simply says that the value of 'mode' in MODE.lookup[mode] in the function set_mode() does not exist. Which I think is odd since there are two mode changes earlier.

I don't have time to look through LoRa.py today to see if I can work out what the problem is. Check your wiring first because this code works just fine on the Pi Dragino HAT.

[RaghavRao]

Hi thanks for your response. I found this library which does exactly what I was looking for: https://github.com/ryanzav/LoRaWAN

…

On Fri, May 28, 2021, 03:38 Brian ***@***.***> wrote: Sorry to see no-one has replied to this, so here goes. The Dragino I have has a Hope RFM95 pcb soldered on it so it should work. The W postfix simply means Worldwide distribution IIRC. You should check the Dragino schematic to see what RPi pin/wiring is used. The keyerror simply says that the value of 'mode' in MODE.lookup[mode] in the function set_mode() does not exist. Which I think is odd since there are two mode changes earlier. I don't have time to look through LoRa.py today to see if I can work out what the problem is. Check your wiring first because this code works just fine on the Pi Dragino HAT. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#8 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABUBDUYP3OT53ZXRSEYM4JTTP5B6DANCNFSM42RLATPQ> .