Unable to join to TTN V3 about dragino

[BNNorman]

It seems there are partial outages of V3 today - but that doesn't explain why I couldn't join yesterday (assuming it was 100% fit yesterday)

[pjb304]

I'm not sure what's going on there. I have a node on my desk which I used to develop the code on and was (and have just tested it again) able to join and send messages. I also have a sensor node on V3 that's sent over 5000 messages over the course of several weeks.

I've not used the cli to configure the devices - rather the web interface, I've attached a screenshot of the network settings that I'm using, in case there are any clues there.

[BNNorman]

Same settings for me. I used the web interface to create the end node. Like you I have a dragino on my desk for dev work and it picks up the gateway on the Humber bridge 11km away. I guess I'll just have to persevere - thanks for confirming the settings.

[pjb304]

If you hadn't said about it working fine in V2 I'd wonder about signal issues. I've certainly seen it where the uplink gets through, but for whatever reason the downlink is never received when working in low signal areas. I have a couple of gateways at home so signal strength isn't an issue for me. Do let me know what the issue turns out to be, I'm curious.

[BNNorman]

I have a TTN indoor gateway which I 'bricked' trying to move it to V3 - only to find it didn't work (after deleting the V2 gateway).
And now the V2 console won't allow creation. So, I guess I have to wait till they sort out the TTIG. :-( Will let you know what I find out, if anything.