Turnigy Plush 40A Oscillation about blheli

[sskaug]

Hi Tim

I really doubt the board versions matter. There is also another user (MayMayDay) that reports oscillations: http://www.rcgroups.com/forums/showthread.php?t=1686498&page=66#post28055739
Could it be similar?

Thanks,
Steffen

[timbit123]

Wow thanks for the fast support. I'll flash my ESCs to version 10.4 and let you know today.

[Edit]
I flashed 10.4 to all esc and same result. I don't understand why everything is smooth on a 3S battery and not on 4S. Also. my two opposite arm on same circuit version are stable. I've got oscillation only on my two opposites arm with new and old esc version.

Thank you again

[sskaug]

I don't know the details between v6.1 and v6.21 HW, but generally the changes have been very minor, some layout details only. And the gain should be set by firmware alone.

Going from 3S to 4S, however will increase your loop gains. So, normally you may need to lower your PIDs.

[timbit123]

I have join my config file that I used for the ESCs. The loop mode is off. Motor Timing is at Medium and PWM at High. I tried to play with the PIDs on the flight controller but even at P=3 on arduCopter 3.0.1 it was oscillating.

Anyway I don't want to bother you with that. I'll stay on 3S and order a new ESC later.

Thanks

[DateTime]
Created=2014-04-18 09:01:24
[Name]
Name=
[Hardware]
Eep_FW_Main_Revision=10
Eep_FW_Sub_Revision=4
Eep_Layout_Revision=16
Eep_BESC_Layout=Turnigy40A
Eep_BESC_MCU=#BLHELI#F310#
Eep_BESC_Mode=2
[Setup]
Eep_Pgm_Motor_Gain=3
Eep_Pgm_Low_Voltage_Lim=1
Eep_Pgm_Startup_Pwr=9
Eep_Pgm_Pwm_Freq=1
Eep_Pgm_Direction_Rev=1
Eep_Pgm_Input_Pol=1
Eep_Enable_TX_Setup=0
Eep_Pgm_Startup_Rpm=1
Eep_Pgm_Startup_Accel=5
Eep_Pgm_Comm_Timing=3
Eep_Pgm_Damping_Force=6
Eep_Pgm_Startup_Method=2
Eep_Pgm_Ppm_Min_Throttle=37
Eep_Pgm_Ppm_Max_Throttle=208
Eep_Pgm_Beep_Strength=60
Eep_Pgm_Beacon_Strength=80
Eep_Pgm_Beacon_Delay=4
Eep_Pgm_Throttle_Rate=13
Eep_Pgm_Demag_Comp=2

[sskaug]

Closing