bieber / sawstop_drawer

Drawer for Sawstop fence tubes

This is a simple drawer that should fit in the ends of the fence tubing on Sawstop PCS and ICS saws with the T Glide fence. You can just pop the end cap off of the tube and this should fit right in.

Pretty much every aspect of this is customizable, and it might even be possible to adapt it to fence tubes for other saws (I have no idea if any other saw uses a similar tube for the fence). Some particularly interesting parameters:

• The SIDE parameter will mirror the model if you set it to "right", enabling you to place the drawer in the right side of the tube.

• You won't want to change the width or height for Sawstop saws, but you can change the LENGTH at will: the only limit is the size of your printer's bed and the length of your fence tube.

• You can add dividers by using the VERTICAL_DIVIDERS, HORIZONTAL_DIVIDERS, and DIVIDER_HEIGHT parameters. The first two parameters are lists of positions in mm where the horizontal and/or vertical dividers will be added, and the third sets the height of the dividers.