dynamic options gives error about dmenu-flexipatch

[bakkeby]

Thanks for the report, looks like a compatibility issue been the dynamic options patch and one of the others. I'll have a look.

[bakkeby]

OK, so the above change addresses the compilation error.

That said I found further conflicts between the dynamic options patch and these patches:

• fuzzymatch patch
• prefix completion patch
• TSV patch

[bakkeby]

OK, I think that's it for this combo.

[fov95]

Noice, thanks a lot .. too bad it wasn't what I was looking for.. I thought it would execute everything I throw at it like when giving it a list with commands, it runs each one as soon as I hover over them with selection cursor.. Is there something that would make that possible?
As an example I have a redshift script that executes, well, a bunch of redshift commands but I would like to see the change before committing to it xD
If one could start dmenu with selection set to none or even one if it does nothing and then run through it an have everything execute would be dope..

[bakkeby]

Yes the dynamic options patch is a bit weird and has limited usability (or I do not have enough gray matter to think of a good use case).

I am not entirely sure what exactly you had in mind, but from what you say it sounds like something that should be possible from a shell script using dmenu to present options.

[fov95]

I''l have a look thanks. =)
To be clear I meant the commands executing BEFORE u press enter in dmenu, excute them as soon as the command gains selection.