adeept / adeept_ultimate_starter_kit_python_code_for_rpi Goto Github PK

I tried to run 12_voltmeter.py from your Adeept_Utimate_Starter_Kit_Python_Code_for_RPi section by copy/pasting it into my Raspberry 3 B. The copy/paste went fine, but when I tried to run it, it couldn't find the module ADC0832_VOL. I'm pretty much a novice at this, but I tried update/upgrade and tried to install the module separately, but it could not be found. Do you know where I can find this Module?

The photo and fritizing diagrams for lesson 3 don't match.

If the circuit for lesson 3 is built from the photo, the code sample is correct. The fritzing diagram doesn't match the photo/code (it has the capacitor base connected to pin #12 instead of #11)

when i run the code for lesson 8, the rgb led lights up but it only shows red. it blinks red 2 times and then it blinks red another time but then immediately changes to a lower frequency and turns off, then starts over.

Hello,

Where do I find the PDF file for the Raspberry Ultimate starter kit ?

THX and best wishes

Niels