8me / nuisance

github mirror of the NUISANCE neutrino interaction generator comparison tool. Compare your favourite neutrino interaction generators to each other and over 350 published data sets

NUISANCE

Authors: Luke Pickering, Callum Wilkinson, Clarence Wret

Previous Authors: Patrick Stowell, Ryan Terri

Contact: (luke[dot]pickering[at]rhul[dot]ac[dot]uk, cwilkinson[at]lbl[dot]gov, c[dot]wret[at]rochester[dot]edu)

--- Compilation The following instructions should be used to build the fitter after checking out.

1. Make sure environmental variables required for the generators you wish to build against are set.
2. In the top nuisance directory make a new build directory:

$ mkdir build && cd build

3. Configure the build with CMake:

$ cmake [-DEXPERIMENTS_ENABLED=ON -DT2K_ENABLED=ON ...] [-DNEUT_ENABLED=ON ...] ../

All arguments are optional. The build will search for configured generators and reweight libraries and enabled them if found. The experiment libraries (containing the publish data comparisons) take a few minutes to build and so can be disabled for convenience with -DEXPERIMENTS_ENABLED=OFF. Individual experimental libraries can then be re-enabled with e.g. -DMINERvA_ENABLED=ON. Generators or reweight libraries that are explicitly enabled are considered requirements and the configuring process will fail if they are not successfully set up. Explicitly disabling a dependency with e.g. -DNOvARwgt_ENABLED=OFF will disable the attempt to configure the given dependency.

List of optional dependencies: NEUT, NuWro, GENIE (v2 or v3), T2KReWeight, NOvARwgt, nusystematics

4. Build and install

$ make install

5. Source the setup script

$ source Linux/setup.sh

If you prefer, most configure variables can be entered through a cmake UI, such as ccmake. e.g. "$ mkdir build && cd build && ccmake ../"

--- Adding Classes The fitter is designed to be easily extended by adding new measurement classes whilst keeping the input convertors and tuning functionality the same. The Devel module folder is setup with some examples of how to add new classes into the framework. Feel free to email me if there are difficulties adding new measurements.

--- Running Fits Whilst running fits is relatively quick and simple, there are now a large range of possible options. Doxygen Documentation is being added to the $NUISANCE/doc/html folder. Refer thre for guidance on how to properly formulate a card file.