how to use MBW Alpha in XYZ plot？ about sd-webui-model-mixer

[vigee88]

Thank you very much for your reply. It can now run normally.I have also tried input 0,0.3,0.5,0.7....before,But I didn't input "".

I often used SuperMerger's XYZ plot to test different MBW effect. But its biggest drawback is cannot preview images, and cant use Rebasin calculation mode. so I hope to use this as a replacement.
I hope to increase the input of MBW preset names in the future.
Thank you again for your enthusiastic and timely response

[wkpark]

MBW alpha A means Block weights in digits such as "0,0.3,0.5,....,0.3" in base, in00, in01,....,out11 order. only float of sets are acceptable.

I guess, you wanted to input series of MBW weights, you can input "0,0.3,0.5....", "0.3,0.4,....","another MBW weigt set",...(and so on). MBW alpha A: only accept comma separated MBW weights, so you have to enclose comma separated weights with ". (RING10_5 MBW set naming are not supported currently.)

If you are using SuperMerger, it seems more easy to use SuperMerger's XYZ plot instead of model-mixer's XYZ plot.