I am getting zero values (all ways) continuously irrespective of the load about hx711py

[aggounix]

Hello, did you fix this problem, I am getting the same one
I am using four 50kg load cell

[jpadams]

same

[tatobari]

I've tested the library and it seems to be working just fine.

It's most important that you submit a schema of how you've wired the loadcells to the HX711. The 50kg loadcells everyone uses, the square ones, don't have an embedded wheatstone bridge and therefore must be connected in a wheatstone bridge layout. Posting your schema will help me help you debug your issue.

[Greenbauer]

had the same issue. changing the mode from BCM to BOARD fixed it for me.

[KaitoCross]

I have the same issue, but I'm using a 20kg load cell (beam type). CLK on Pin 20, DT on 21. Chip & load cell are working as intended on my Arduino, but is giving me zeros on the Raspberry